Bosch dishwasher repair in Winnipeg usually costs $150 to $400 in parts and labour, and on a Bosch it is nearly always worth doing. Most calls come down to four things: the leak protection has tripped (E15), the drain is blocked (E24 or E25), the water is not heating (E09 or E01), or the dishes are coming out wet. A drain pump, latch, valve or float switch sits at the low end; a heat pump or control module sits at the top. We work on every Bosch series, 100 through Benchmark, usually same-day or next-day, and you hear the firm price before the dishwasher comes out of the cabinet. For every other brand, see dishwasher repair Winnipeg.
Need it today? Call
(431) 441-3572We book a real arrival window across Winnipeg, diagnose the fault, and quote a firm price before any work.
- Same-day & next-day service
- Firm price before any work
- Service call credited to the repair
- All major brands, one-visit repairs
Winnipeg & surrounding area
Book a repair
Tell us what’s broken and we’ll come back the same business day with a time and a price.
E15 on a Bosch: the code most calls start with
E15 means water has reached the base pan under the tub, and the leak protection has shut the dishwasher down. Under the tub sits a shallow pan with a float in it. When enough water collects to lift the float, the dishwasher stops washing and usually runs the drain pump to protect your floor.
The water can come from three places:
- A real leak. A loose hose clamp, a cracked sump, a pump seal or a door gasket that lets water run down inside the cabinet. This is the one that matters, because resetting the code without finding it just means the next load trips it again.
- Suds. Hand dish soap, a rinse-aid overfill or a double dose of detergent makes foam that spills over the sump and into the pan. One load of the wrong soap can trip E15 on a perfectly healthy machine.
- A failed float switch. Less common, but a stuck or faulty switch can report water that is not there.
Drying the pan clears the code. Finding the source is what stops it coming back, and that means sliding the dishwasher out and looking underneath with it running. We do that on the first visit.
If water is on the floor, turn off the dishwasher's water supply under the sink and switch off the breaker before you do anything else.
Bosch dishwasher error codes
Bosch shows codes on the display, or on some models as a combination of flashing lights. These are the ones Winnipeg owners read to us most.
| Code | What it usually means |
|---|---|
| E15 | Water in the base pan; leak protection has tripped |
| E24 | Drain hose kinked or blocked, or the sink drain or garburator connection is clogged |
| E25 | Drain pump blocked, often by glass, a seed or a label behind the pump cover |
| E22 | Filters clogged enough to slow the wash |
| E09 or E01 | Heating fault: the heat pump, its heater, or the module that drives it |
| E14 | Flow meter fault: the machine cannot measure how much water came in |
| E21 | Wash pump motor fault |
| E23 | Drain pump fault |
Bosch codes are consistent across most models but not all of them, so read the code exactly as it shows and we confirm it at the machine. On many Bosch dishwashers, E24 and E25 are worth trying yourself first, because the fix can be free.
Clearing E24 and E25 yourself
E24 is usually outside the dishwasher. Check the drain hose under the sink for a kink, especially if something was recently pushed into the cabinet. If the dishwasher drains into a garburator that was just installed, the knockout plug inside the garburator's dishwasher inlet may never have been removed. A sink that drains slowly will also back water up into the dishwasher.
E25 is usually behind the pump cover. Pull out the bottom rack, lift out the filter assembly, and you will see a small cover in the sump below it. On most Bosch models it pops off with a spoon handle. Behind it is the drain pump impeller, and the usual culprits are a piece of broken glass, a cherry pit or a label from a jar. Turn the impeller gently by hand once it is clear. Wear gloves for the glass.
If the code returns with the hose straight and the pump clear, the drain pump has failed. That is a $180 to $350 repair.
Bosch heating and drying problems
The dishes are clean but wet. Bosch dries by condensation, not with an exposed heating element, so a Bosch never dries plastic the way an old element dishwasher did. Wet plastic alone is normal. Wet glass and ceramic usually means the rinse aid has run out or is set too low, the load is crammed, or the door was opened too early. Newer 800 Series and Benchmark models with CrystalDry use a mineral that releases heat to help drying, and some models open the door slightly at the end of the cycle; both are features, not faults.
The water stays cold, or the cycle runs for hours. Modern Bosch dishwashers heat water in a heat pump, a unit that combines the wash pump and the heater. When the heater fails, the machine shows E09 or E01, or simply runs a very long cycle trying to reach temperature. The heat pump is the most expensive common Bosch part, in the $220 to $400 range with labour.
Dishes come out gritty. The three-part filter in the sump floor is loaded, or the spray arms are blocked. Twist the filter out, rinse it under the tap, and clear the spray arm holes with a toothpick. Bosch expects you to clean the filter every few weeks, and most owners have never seen it.
Bosch dishwasher repair costs in Winnipeg
Bosch is priced from the same parts-and-labour ranges as every dishwasher we repair in Winnipeg. The badge does not move the price; the part does.
| Bosch dishwasher repair | Typical range |
|---|---|
| Door latch or door switch | $150 to $280 |
| Door gasket or seal | $150 to $280 |
| Water inlet valve or flow meter | $160 to $300 |
| Float switch and leak source repair (E15) | $150 to $300 |
| Drain pump (E25, E23) | $180 to $350 |
| Heat pump or wash pump (E09, E01, E21) | $220 to $400 |
| Control module | $200 to $400 |
The diagnostic call is typically $90 to $130, credited to the repair when you go ahead. A breakdown of every dishwasher part and symptom, any brand, is on dishwasher repair cost Winnipeg.
Is a Bosch dishwasher worth repairing?
Almost always, for the faults above. A Bosch has a stainless tub, a well-built frame and parts that stay available for years, so a $150 to $350 repair on a machine that otherwise cleans well is money well spent. The exceptions are a heat pump and a control module failing together, or a dishwasher past ten years with a cracked sump. A new Bosch costs well above a basic dishwasher, which pushes the replace line later than it sits for other brands. We give you the number and the honest call before any part is ordered, and the repair-or-replace calculator runs the same math.
Winnipeg notes for Bosch owners
- Scale on the heater. The City publishes Shoal Lake water at roughly 70 to 87 mg/L, moderately hard. That is not enough to wreck a dishwasher, but over years it leaves scale in the heat pump and on the spray arm holes. A descaling cleaner every couple of months is cheap insurance on the most expensive Bosch part.
- The model number lives on the door edge. Open the door and look at the top or side edge of the inner door. You want the E-Nr (the model) and the FD number (the production code). With both, we bring the right heat pump or module the first time.
- Cold kitchens in January. A dishwasher on an outside wall takes in colder water in deep winter, which lengthens the cycle. Running the kitchen tap until it is warm before you start the dishwasher helps more than people expect.
Do this before you book
- Rinse the filter in the tub floor and check the spray arms spin freely.
- Check the pump cover for glass or debris if the code is E25.
- Straighten the drain hose under the sink, and run the garburator first if you have one.
- Switch to proper dishwasher detergent if anyone has used hand soap, then run an empty rinse.
- Note the E-Nr and FD number from the door edge.
Questions we get asked
How much does Bosch dishwasher repair cost in Winnipeg?
Most Bosch dishwasher repairs in Winnipeg run $150 to $400 in parts and labour. A latch, gasket, valve, float switch or drain pump is at the low end, and a heat pump or control module at the top. The $90 to $130 diagnostic call is credited when you go ahead.
What does E15 mean on a Bosch dishwasher?
Water has collected in the base pan under the tub and the leak protection has stopped the machine. It can be a real leak, foam from the wrong soap, or a faulty float switch. We find the source rather than just drying the pan, because the code comes back if the leak is still there.
How do I fix E24 or E25 on my Bosch dishwasher?
E24 is usually a kinked drain hose or a clogged sink or garburator connection. E25 is usually debris behind the pump cover in the sump. Clear both with the power off. If the code returns, the drain pump has likely failed.
Why does my Bosch dishwasher not dry the dishes?
Bosch dries by condensation, so plastic often stays wet. If glass and ceramic are wet too, top up the rinse aid, raise its setting, and leave the door shut until the cycle ends. A cold wash with E09 or E01 points to the heater.
Is a Bosch dishwasher worth fixing?
Usually yes. Bosch dishwashers are well built and most repairs cost a fraction of a new one. A heat pump and module failing together, or a cracked sump on an older machine, are the cases where replacing can win.
Are you Bosch's factory service?
No. We are an independent repair service and are not affiliated with Bosch or BSH. If your dishwasher is still under Bosch's warranty, contact Bosch first so the coverage is protected; after that, we are usually the quicker way to get it running.
Reviewed October 2026.
Need it today? Call
(431) 441-3572We book a real arrival window across Winnipeg, diagnose the fault, and quote a firm price before any work.
- Same-day & next-day service
- Firm price before any work
- Service call credited to the repair
- All major brands, one-visit repairs
Winnipeg & surrounding area
Book a repair
Tell us what’s broken and we’ll come back the same business day with a time and a price.