Home / Dishwasher Repair Cost in Winnipeg

Dishwasher Repair Cost in Winnipeg

Reviewed October 2026 · Winnipeg, Manitoba

$150 to $400most leaks $150 to $300
Same-daymost Winnipeg calls
Best forpricing a dishwasher repair

Dishwasher repair in Winnipeg usually costs $150 to $400 in parts and labour. Most leaks, from a door gasket, latch or hose, cost $150 to $300. A drain pump is $180 to $350. A circulation pump at $220 to $400 or a control board at $200 to $400 sits at the top, and those are the two repairs that can push an older dishwasher toward replacement. Add a $90 to $130 diagnostic call, which is credited to the repair when you go ahead, and you approve one firm total before any work. To book rather than price, use dishwasher repair Winnipeg.

(431) 441-3572

Need it today? Call

(431) 441-3572

We book a real arrival window across Winnipeg, diagnose the fault, and quote a firm price before any work.

  • Same-day & next-day service
  • Firm price before any work
  • Service call credited to the repair
  • All major brands, one-visit repairs
Call (431) 441-3572

Winnipeg & surrounding area

Book a repair

Tell us what’s broken and we’ll come back the same business day with a time and a price.

No obligation. The price is quoted before any work. Your details go only to our Winnipeg team.

Dishwasher repair prices by part

Typical Winnipeg ranges, parts and labour together. They match the figures on the rest of this site, so a quote can be checked against them.

Part Typical repair, Winnipeg What it does when it fails
Door latch / door switch $150 to $280 The cycle will not start, or stops partway
Door gasket / seal $150 to $280 Water seeps out along the front edge
Water inlet valve $160 to $300 No fill, a slow fill, or a valve that hums
Drain pump $180 to $350 Water stays in the tub; the pump hums or buzzes
Control board / touchpad $200 to $400 Buttons dead, lights flashing, cycles that make no sense
Circulation / wash pump $220 to $400 Dishes come out dirty even with clean spray arms

What it costs by problem

You call about what the dishwasher is doing, not about a part. This is how the usual complaints price out:

The problem Most likely cause Typical cost
Water standing in the bottom Clogged filter, drain hose, garburator port, or the drain pump Free if it is the filter; $180 to $350 for a pump
Leaking onto the floor Door gasket, latch, a hose or a valve connection $150 to $300
Leaking from under the tub The pump seal Up to about $400, because the pump is part of the job
Dishes not getting clean Blocked spray arms, scale on the jets, or the circulation pump Often cleaning and descaling; $220 to $400 for a pump
Will not start Door latch or switch, or the control board $150 to $280 for a latch; $200 to $400 for a board
Will not fill Inlet valve, or a closed shut-off under the sink $160 to $300 for a valve; free if it is the shut-off
Dishes not drying Rinse aid, loading, the heating element or vent Often free; an element is quoted by model

Standing water has its own step-by-step guide, with six free checks and the sink test that tells a dishwasher fault from a blocked drain: dishwasher not draining in Winnipeg.

What a dishwasher leak costs to fix

A leak sounds expensive and usually is not. Most dishwasher leaks come from the front: a door gasket that has hardened or has grit stuck to it, a latch that no longer pulls the door tight, or a loose hose or valve connection underneath. Those sit at $150 to $300. The pricier leak is the one from a failed pump seal under the tub, up to about $400, because the pump comes out with it.

Before booking a leak, check two free things. Wipe the door gasket and the tub edge where it seals, since a line of food or grit breaks the seal. And make sure you are using dishwasher detergent, not dish soap: a squirt of hand dish soap fills the tub with suds that pour out the door and look exactly like a leak.

If water is reaching an electrical outlet or the floor under the cabinet, turn the dishwasher off at the breaker and close the shut-off valve under the sink before mopping up.

Is it worth repairing a dishwasher?

Usually, yes, when it is under about 8 years old. A comparable new dishwasher is around $800 before delivery, removal and installation, while most repairs run $150 to $350. Dishwashers last about 8 to 10 years, and the honest rule is this: once a repair costs more than half the price of a comparable new machine and the dishwasher is past its years, replacing makes more sense.

Dishwasher age Latch, gasket, valve or drain pump ($150 to $350) Circulation pump or control board ($200 to $400)
Under 5 years Repair Repair
5 to 8 years Repair Usually repair, but ask for the comparison
9 years or more Repair if it otherwise cleans well Usually replace, especially with other problems

Build quality moves the line too. Bosch and KitchenAid dishwashers cost real money to replace and take a repair well, so they stay worth fixing for longer. Bosch owners can read their error codes, including the E15 leak code, on Bosch appliance repair Winnipeg. We repair dishwashers and do not sell them, so the answer you get does not depend on what we would earn.

What replacing a dishwasher really costs

When people search for dishwasher replacement cost, they are usually weighing it against a repair quote. The comparison is not the price tag alone. A new dishwasher also brings delivery, removing the old unit, and installation, which means disconnecting and reconnecting the water supply, the drain and the power under your counter. Price those out from whoever sells you the new machine before you decide, then compare that full number against the repair. If you do replace it, our guide to appliance disposal in Winnipeg covers the 4R Depots and retailer haul-away for the old one.

Plumber or appliance technician: which bill is it?

Paying the wrong trade is the most common way a dishwasher repair costs more than it should. Fill the kitchen sink a few inches and pull the plug. If the sink drains slowly too, the blockage is probably in the drain line the sink and dishwasher share, and that is a plumber's job. If the sink drains freely and the dishwasher still holds water, or will not fill, the fault is inside the dishwasher and an appliance technician is the right call. We will say so on the phone when what you describe sounds like plumbing, rather than charge a diagnostic call to find a healthy pump.

Winnipeg water and what it does to the bill

The City of Winnipeg publishes Shoal Lake water hardness at roughly 70 to 87 mg/L, which is moderately hard. That is not enough to kill a dishwasher, but over years it leaves scale on the heating element, the spray jets and the valves, and it is a common reason dishes stop coming out clean. That complaint is often fixed by descaling and clearing the jets rather than buying a part, and we start with the cheaper fix when it solves the problem.

Four ways to keep the bill down

  1. Clean the filter monthly. Twist it out of the floor of the tub, rinse it, and scrub the mesh. It prevents most drain and cleaning calls.
  2. Run an empty hot cycle with a dishwasher cleaner or citric acid every few months to clear Winnipeg's light scale.
  3. Keep rinse aid topped up. It fixes more spotting and drying complaints than any repair.
  4. Tell us the brand, the model number and any error code when you book, so the likely part comes out on the first trip. The model label is usually on the edge of the door or the side of the tub opening.

Questions we get asked

How much does dishwasher repair cost in Winnipeg?

Most dishwasher repairs in Winnipeg cost $150 to $400 in parts and labour. Latches, gaskets, valves and drain pumps sit at $150 to $350; a circulation pump or control board is $200 to $400. The $90 to $130 diagnostic call is credited when you go ahead.

How much does it cost to fix a leaking dishwasher?

Usually $150 to $300, because most leaks come from the door gasket, the latch, a hose or a valve connection. A leak from the pump seal under the tub runs up to about $400.

How much is a dishwasher drain pump replacement?

Typically $180 to $350 in Winnipeg, parts and labour together. Clean the filter and run the garburator first, because a blockage causes the same standing water and costs nothing to clear.

Is it cheaper to repair or replace a dishwasher?

Repair is cheaper in most cases. A comparable new dishwasher is around $800 before delivery and installation, while most repairs cost $150 to $350. Replacing wins when an older machine needs a control board or circulation pump and has other problems too.

Do you charge to diagnose a dishwasher?

Yes, a diagnostic call of about $90 to $130 covers the trip and finding the fault. It is credited to the repair if you approve it, so you do not pay for the visit twice.

Why does a dishwasher control board cost so much?

The board itself is the expensive part, and it varies a lot by brand and model, which is why a board job runs $200 to $400. Before replacing one, we rule out the cheaper parts that cause the same symptoms, like a door switch or a latch.

Reviewed October 2026.

(431) 441-3572

Need it today? Call

(431) 441-3572

We book a real arrival window across Winnipeg, diagnose the fault, and quote a firm price before any work.

  • Same-day & next-day service
  • Firm price before any work
  • Service call credited to the repair
  • All major brands, one-visit repairs
Call (431) 441-3572

Winnipeg & surrounding area

Book a repair

Tell us what’s broken and we’ll come back the same business day with a time and a price.

No obligation. The price is quoted before any work. Your details go only to our Winnipeg team.

Broken appliance? Let's get it running.

Same-day service across Winnipeg. Straight pricing, quoted before any work.

Call nowGet a quoteRepair or replace?