Home / Dryer Repair Cost in Winnipeg

Dryer Repair Cost in Winnipeg

Reviewed November 2026 · Winnipeg, Manitoba

$150 to $350motor about $400
Same-daymost Winnipeg calls
Best forpricing a dryer repair

Dryer repair in Winnipeg costs $150 to $350 for almost every common fault, parts and labour together. A thermal fuse or thermostat is $150 to $280, a heating element or gas igniter $180 to $350, a drive belt $150 to $250, and drum rollers or an idler pulley $180 to $320. A motor, at about $400, is the one part that can make an old dryer not worth fixing. The diagnostic visit is $90 to $130 and comes off the repair when you go ahead. If the machine is fine and the vent is the problem, that is a separate and cheaper job: dryer vent cleaning Winnipeg is $120 to $180 for a standard run. To book rather than price, start at dryer repair Winnipeg.

(431) 441-3572

Need it today? Call

(431) 441-3572

We book a real arrival window across Winnipeg, diagnose the fault, and quote a firm price before any work.

  • Same-day & next-day service
  • Firm price before any work
  • Service call credited to the repair
  • All major brands, one-visit repairs
Call (431) 441-3572

Winnipeg & surrounding area

Book a repair

Tell us what’s broken and we’ll come back the same business day with a time and a price.

No obligation. The price is quoted before any work. Your details go only to our Winnipeg team.

What the call usually costs, by what the dryer is doing

Nobody phones about a thermal fuse. They phone because the towels came out cold, or the drum stopped turning, or the laundry room smells hot. So the table starts from the complaint and works back to the part and the price. Every figure is the same range published on the rest of this site, which means a quote from us or from anyone else can be held against it.

What you noticed What it usually is What it costs in Winnipeg
Drum turns, air stays cold (electric) Thermal fuse, cycling thermostat or heating element $150 to $280 for a fuse or thermostat; $180 to $350 for an element
Drum turns, air stays cold (gas) Igniter or gas valve coils $180 to $350
Heats, but a load takes two or three cycles Lint-packed vent or an iced exterior hood, sometimes a weak element $120 to $180 for a standard vent run, $80 to $120 if done during a repair visit; $180 to $350 if the element has gone
Motor hums, drum does not move Snapped belt, seized roller or jammed idler $150 to $250 for a belt; $180 to $320 for rollers or the idler
Dead: no light, no hum, nothing Door switch, start switch, thermal fuse or the breaker Nothing if it is the breaker; $150 to $260 for a switch; $150 to $280 for the fuse
Thumping or a squeal that rises with speed Flat-spotted rollers, glazed idler pulley or a worn blower wheel $180 to $320
Stops a few minutes into the cycle Motor overload tripping from heat or restricted airflow Often the vent ($120 to $180); a motor is about $400
Smell of hot lint or scorching Lint packed around the element housing or a motor on its way out Stop using it; priced after the inspection

Most Winnipeg dryer repairs land between $150 and $350, and the vent decides whether the repair holds. That second half is the part the price table cannot show you, so it gets its own section below.

Price by part, for comparing quotes

Part Typical Winnipeg price, installed
Thermal fuse or thermostat $150 to $280
Heating element (electric) $180 to $350
Igniter or gas valve coils (gas) $180 to $350
Drive belt $150 to $250
Drum rollers or idler pulley $180 to $320
Door switch or start switch $150 to $260
Drive motor About $400
Control board, moisture sensor bars, drum glides, blower wheel Quoted on your model before any work

The diagnostic call of $90 to $130 covers the trip and finding the fault, and it is credited to the repair if you approve it. On a visit where the dryer turns out to be fine and the vent is the problem, you pay for the vent job, not for the diagnosis and the vent job.

Why the thermal fuse keeps coming back

The thermal fuse is the cheapest part in the table and the one that gets replaced for the wrong reason most often. It is a one-time safety link: when the air inside the dryer gets hotter than it should, the fuse opens and the heat is gone for good. Fitting a new one takes minutes. But a fuse does not blow on its own. Nearly every time, the dryer overheated because the exhaust could not get out, and a new fuse in front of the same blocked duct blows again inside a month.

So on any no-heat call the exhaust gets checked before the fuse is signed off, and if the duct is packed, clearing it is part of the repair, not an upsell. On the same visit that is $80 to $120 rather than the $120 to $180 of a vent-only booking. The one thing you should never accept is a bypassed fuse: the dryer heats again, and it has no protection left.

The Winnipeg part: frost at the hood

Every city has lint. Winnipeg adds ice. Warm, wet dryer air meets outside air far below freezing at the exterior hood, and the moisture freezes on the flap and the last foot of duct. On a cold week the flap can be held half open by ice, or frozen shut, and the dryer breathes through whatever gap is left. The owner sees a machine that still heats but takes forever, and sometimes the thermal fuse goes with it.

That is why the "takes two cycles" row above points at the vent first. Before you book, go outside while the dryer is running and watch the hood: the flap should lift and you should feel a steady push of warm air. If it barely moves, or there is a frost beard around it, you are looking at the cause, and the fix is a cleaning, not a part. The dryer vent cleaning Winnipeg page covers the whole run, including long second-floor runs ($180 to $260), a replacement hood ($60 to $120 added) and swapping a plastic or foil hose for semi-rigid metal ($30 to $60 added).

What the fire service asks you to do

Dryers are one of the few appliances with a standing fire warning from the city. In its April 29, 2026 release on six structure fires, the Winnipeg Fire Paramedic Service wrote that an apartment fire on Chandos Avenue was, on preliminary observation, "accidental and caused by a malfunction in the operation of a clothes dryer", and it repeated its clothes dryer safety list: never run a dryer without a lint filter, clean the filter after every load, inspect the venting periodically for lint buildup and for duct that is damaged, crushed or restricted, make sure the outdoor flap opens while the dryer runs, and never leave a dryer running when you leave the house.

A burning smell, visible scorching, or a dryer that is hot to the touch on the outside is not a "book it for next week" call. Unplug it, leave it off, and phone. We put those at the front of the line.

Natural Resources Canada's laundry efficiency page makes the same point from the hydro-bill side: clean the lint trap after every load to increase airflow, sort loads by thickness so towels are not holding back the light things, and do not overfill, because an overfilled drum needs extra cycles and strains the motor. A dryer that is cared for that way rarely needs the expensive repair.

Gas dryers: same prices, one extra rule

A gas dryer has every mechanical part an electric one has, plus a burner. When it tumbles cold, the fault is almost always the igniter, which glows but no longer gets hot enough, or the gas valve coils, which fail to open the valve. Both are stocked parts, both sit in the $180 to $350 window, and both are usually done in one visit. The price is no higher than an electric element.

The rule is about what you do yourself. On an electric dryer you can check the breaker and look at the element. On a gas dryer, nothing past confirming the supply valve is open is a homeowner job. If you smell gas, Manitoba Hydro's natural gas safety page says to get people and pets out immediately, leave the doors open on your way, and call 911 or Manitoba Hydro at 1-888-624-9376 from a safe place, staying at least 100 metres away until you are told it is safe. Book the repair after that, not before.

Repair or replace: the two numbers that decide it

Dryers are the most repair-worthy machine in the house. They last about 13 years in the NAHB component-life study our cost page cites, which is longer than a washer, and the parts that fail are cheap relative to a new one. So the honest test has only two inputs, the age and the part:

Dryer age Fuse, element, igniter, belt, rollers or switch ($150 to $350) Motor (about $400)
Under 8 years Repair Repair
8 to 12 years Repair Usually repair if the drum, bearings and cabinet are sound
13 years or more Repair if it is otherwise quiet and dry-running Compare against a new machine before spending

A motor on a dryer past its expected life is the only common case where we tell you to price a replacement first. Everything else in the table is a yes. If you want the arithmetic rather than the rule of thumb, the repair-or-replace calculator takes the age, the quote and the price of the new unit you are looking at, and shows its work. If the machine is going, appliance disposal in Winnipeg explains the 4R Depots and retailer haul-away.

Washer and dryer down together

When both laundry machines are misbehaving, one visit covers the pair under a single diagnostic call, and each machine gets its own firm price before anything is opened. A washer that spins weakly also makes a perfectly good dryer look slow, because the clothes arrive heavier than they should. How that visit is priced is on washer and dryer repair Winnipeg, and washer faults on their own are on washing machine repair cost Winnipeg.

Brand notes that move the price

Belts, fuses, rollers and switches cost about the same whatever the badge. Where brand shows up is in two places. Samsung dryers report faults with codes, and reading HE, tO or the airflow light correctly saves a second trip; that is on Samsung dryer repair Winnipeg. And boards on newer touch-panel dryers from any maker are the one part priced on the model rather than from the table. Everything else is covered under Whirlpool appliance repair Winnipeg, LG appliance repair Winnipeg, Maytag and GE, and the whole-house price list is on appliance repair cost in Winnipeg.

Five free checks before you pay for a visit

  1. The breaker. An electric dryer runs on a 240-volt double breaker. If one half trips, the drum turns and the air stays cold. Switch the pair fully off, then on.
  2. The hood outside. Flap lifting, warm air pushing, no ice. If not, the vent is your problem.
  3. The lint screen slot. Pull the screen and shine a light down the housing. Packed lint there chokes the whole machine.
  4. The door. Close it firmly; a door switch that is not quite made leaves a dryer dead. If the drum light does not go out when you press the switch by hand, that switch is $150 to $260.
  5. The gas valve. On a gas dryer, confirm the handle on the supply line is in line with the pipe. Then stop; the rest is ours.

Renting in Winnipeg? Who pays

If the dryer came with the unit and failed through normal use, the repair is generally the landlord's under Manitoba's Residential Tenancies rules, not yours. How to ask, what the Branch expects in writing and what happens when a landlord does not act are on landlord and tenant appliance repair in Winnipeg.

Questions we get asked

How much does dryer repair cost in Winnipeg?

Most dryer repairs in Winnipeg cost $150 to $350, parts and labour together. A thermal fuse or thermostat is $150 to $280, a heating element or gas igniter $180 to $350, a belt $150 to $250 and rollers or an idler $180 to $320. A motor is about $400. The $90 to $130 diagnostic call is credited to the repair.

What does it cost to fix a dryer that runs but does not heat?

Usually $150 to $350. On an electric dryer the thermal fuse or thermostat is the cheap end at $150 to $280 and the heating element the top end at $180 to $350; on a gas dryer the igniter or valve coils are $180 to $350. If the fuse blew because the vent was blocked, clearing the vent is part of the job, or the new fuse goes too.

Is it worth repairing a 10 year old dryer?

Almost always. Dryers last about 13 years and a fuse, element, belt or set of rollers costs a small share of a new machine. The exception is a motor, at about $400, on a dryer that is also noisy or rusting; then compare against a new one first.

How much is a dryer belt?

$150 to $250 installed in Winnipeg. The belt itself is inexpensive; the price is mostly getting the cabinet open and checking the idler and rollers while it is apart, because a worn idler is what snaps belts.

Why does my dryer take two cycles when it still gets hot?

Because the air cannot get out. A lint-packed duct or an iced-up exterior hood in winter holds the wet air in the drum. Vent cleaning is $120 to $180 for a standard run, or $80 to $120 added to a repair visit. A weak element causes the same symptom less often.

Do you charge to come out and look?

Yes, a diagnostic call of $90 to $130 that covers the trip and finding the fault. If you go ahead with the repair the same visit, that amount comes off the bill, so you do not pay for the look twice.

Is a gas dryer more expensive to repair than electric?

No. The igniter or valve coils on a gas dryer cost $180 to $350, the same window as an electric heating element. The difference is safety: past checking that the supply valve is open, a gas dryer is a technician's job, and a gas smell means leave and call Manitoba Hydro or 911 before anything else.

Reviewed November 2026.

(431) 441-3572

Need it today? Call

(431) 441-3572

We book a real arrival window across Winnipeg, diagnose the fault, and quote a firm price before any work.

  • Same-day & next-day service
  • Firm price before any work
  • Service call credited to the repair
  • All major brands, one-visit repairs
Call (431) 441-3572

Winnipeg & surrounding area

Book a repair

Tell us what’s broken and we’ll come back the same business day with a time and a price.

No obligation. The price is quoted before any work. Your details go only to our Winnipeg team.

Broken appliance? Let's get it running.

Same-day service across Winnipeg. Straight pricing, quoted before any work.

Call nowGet a quoteRepair or replace?