Home / Washing Machine Smell? Here's Why, and How to Clear It

Washing Machine Smell? Here's Why, and How to Clear It

Reviewed November 2026 · Winnipeg, Manitoba

Free to fixcleaning clears most smells; a torn door boot runs $200 to $400
Same-daymost Winnipeg calls
Best fora musty or sour smell, mildew in the door boot

A washing machine smells because a film of detergent residue, fabric softener, body oil and mildew has built up in the parts that stay wet between loads: the rubber door boot on a front-loader, the detergent drawer, and the pump filter at the bottom front. Cold washes and too much detergent feed that film, and a sealed front door lets it grow in the dark. In almost every case the fix is free: run your washer's own hot cleaning cycle, wipe the boot and drawer, and leave the door open to dry. The smell only means a repair when water is sitting where it should drain, or the boot has torn. Below is how to clear it, how to keep it gone in a Winnipeg home, and how to tell a cleaning job from a Washer repair Winnipeg call.

(431) 441-3572

What the smell actually is

The musty, sour or "wet dog" smell is biofilm: a living layer of soap scum, grease from clothes, softener and mould that coats the inside of the drum, the gasket folds and the hoses you cannot see. High-efficiency (HE) front-loaders are the worst for it because they use very little water, seal shut, and run cool. There is simply never enough hot water, air or sunlight inside to keep the film from forming. Top-loaders smell less often, but they are not immune, especially around the fabric softener dispenser and under the agitator.

This matters because scrubbing the drum you can see does almost nothing. The smell lives in three hidden spots, and all three have to be cleared.

The three places the smell hides

1. The door boot (front-loaders)

The rubber gasket at the front of the drum has folds designed to seal the door. Those folds trap water, lint, coins and hair after every wash. Pull the top of the boot back and look inside with a flashlight. Black spotting and a slimy feel is mildew. Whirlpool's own care guidance says to wipe the gasket and the glass clean and to leave the door open between loads so it can dry, and Samsung's Canadian guide says to wipe the door, gasket and detergent area weekly. Most boot mildew is a cleaning job and a habit change, not a part. A boot that is torn or peeling is a different matter, and that is covered further down.

2. The detergent drawer

The dispenser drawer and the cavity behind it collect undiluted softener and gummy detergent that never fully rinse away, and that paste grows mould. On most washers the drawer pulls all the way out (there is usually a tab or a release to press). Soak it in hot water, scrub the softener compartment with an old toothbrush, and clean the roof of the empty cavity where sludge hangs down. LG's support pages recommend cleaning the dispenser weekly and the door gasket monthly for exactly this reason.

3. The pump filter (front-loaders and newer top-loaders)

Behind the small access door at the bottom front corner sits the drain pump filter. Its job is to catch what falls out of pockets, and whatever it catches sits in standing greywater between loads. A packed filter is one of the most overlooked sources of a bad smell. Unscrew it slowly over a shallow tray (it holds water), clear out the lint and debris, rinse it, and screw it back hand-tight. If you find the filter and the water underneath it foul, that standing water may point to a slow drain as well, which is covered on washer not draining.

The monthly fix: your washer's own cleaning cycle

Every HE washer made in the last fifteen years has a dedicated hot cleaning cycle, and running it is the single most effective thing you can do. It heats water far hotter than a normal wash and runs long enough to break down the biofilm. Use it with an affresh or similar washer-cleaning tablet, or the plain cycle on a maintenance schedule. Do not run it with laundry inside.

Brand Cycle name How often the maker says Reminder on the panel
LG Tub Clean About once a month; once a week for three weeks if it already smells tcL appears after about 30 washes
Samsung Self Clean / Eco Drum Clean Once a month Reminder light after about 20 washes (top load) or 40 washes (front load)
Whirlpool, Maytag, Kenmore (Whirlpool-built) Clean Washer with affresh At least once a month or every 30 wash cycles, whichever comes first Clean Washer light or message

A few rules the makers are firm about:

  • Run the cycle with the drum empty. Samsung warns never to run Self Clean with anything in the tub.
  • For routine cleaning, do not add bleach. Samsung says bleach belongs only in a mildew or mould situation, not in a maintenance run.
  • With the Whirlpool procedure, put the affresh tablet in the bottom of the drum, not the dispenser, add no detergent, and run a Rinse and Spin afterward to clear the cleaner out.
  • If a musty smell survives three weekly cleaning cycles, the makers all say the same thing: it is time for service, because something is holding water that should not be.

Why Winnipeg washers smell

A few local habits make the problem worse here than the manufacturer manuals assume.

Cold washes. Winnipeggers run cold cycles to keep the Manitoba Hydro bill down and because our clothes are not heavily soiled most of the year. Cold water never melts the greasy film the way an occasional hot wash does. If every load is cold, the biofilm only grows. The monthly hot cleaning cycle is what replaces the hot wash your machine never otherwise gets.

Too much detergent in moderately hard water. The City of Winnipeg's water quality reports put our Shoal Lake supply at roughly 80 mg/L of hardness as calcium carbonate (the 2025 report runs about 78 to 82, the 2024 average was 80.3), which is moderately hard but not hard enough to need extra soap. People pour in more than the line calls for, and HE machines cannot rinse the surplus away. That leftover detergent is food for the film, and it is the most common cause we see. Use the smallest dose of HE detergent the bottle lists, not the biggest.

Basement laundry. A great many Winnipeg homes do laundry in a finished or unfinished basement, where the air is cool and damp for much of the year. A front-load boot left sealed in a humid basement mildews faster than one in a bright main-floor laundry. Leaving the door and the detergent drawer open between loads matters more here, not less.

Habits that keep it gone

  • Leave the door and the detergent drawer open after every load so the drum dries out.
  • Run the monthly cleaning cycle, and reach for it weekly for three weeks if a smell has already set in.
  • Wipe the door boot dry and pull a cloth through its folds after a wash, especially in a basement.
  • Measure HE detergent to the low line, and skip liquid fabric softener, which leaves the stickiest residue.
  • Do not leave wet laundry sitting in the drum. Whirlpool notes that clothes left in the basket are a direct cause of mildew. Move them to the dryer promptly, which matters more when a machine shares a damp basement with the Washer and dryer repair Winnipeg pair.

When a smell means a repair, not a cleaning

Most smells clear with cleaning. These do not, and they are the ones worth a technician's visit.

What you notice What it usually is
Cleaned the boot, drawer and filter, ran three tub-clean cycles, still musty Water standing in the sump, hoses or a clogged drain path
The boot itself is torn, peeling or will not come clean A door boot seal that needs replacing, $200 to $400 in Winnipeg
Foul water sitting under the pump filter, drains slowly A failing drain pump or a blocked drain, see Washing machine repair cost Winnipeg
A hot, electrical or burning smell during a cycle Stop the washer at the breaker. This is a motor, belt or wiring fault, not mildew, and it needs service now

A burning or electrical smell is the one exception to everything above. It is never a cleaning problem. Switch the washer off at the breaker and book a repair before running it again.

What the repairs cost in Winnipeg

Cleaning costs nothing but your time. If the smell turns out to be a part, the common ones on a washer are a door boot seal at $200 to $400 and a drain pump at $180 to $350, both installed. The diagnostic visit is $90 to $130 and is credited toward the repair if you go ahead. Every washer part and fault, priced, is on Washing machine repair cost Winnipeg, and the repair-or-replace calculator runs the numbers on your own machine.

Brand matters for where the smell hides. If yours is a front-load Samsung, Samsung washer repair Winnipeg covers the Self Clean cycle and the boot in detail, and for a Whirlpool, Maytag or Kenmore, Whirlpool washer repair Winnipeg does the same.

Questions we get asked

Why does my washing machine smell bad?

A film of detergent residue, grease and mildew builds up in the parts that stay wet: the front-load door boot, the detergent drawer and the pump filter. Cold washes and too much detergent feed it, and a sealed door lets it grow. Clearing all three spots and running a hot cleaning cycle fixes it in almost every case.

How do I get the smell out of my front-load washer?

Wipe the door boot and pull a cloth through its folds, pull out and scrub the detergent drawer, and clean the pump filter at the bottom front. Then run the machine's Tub Clean, Self Clean or Clean Washer cycle hot with the drum empty. Repeat the cycle weekly for three weeks if the smell is strong.

How often should I run the washer cleaning cycle?

About once a month. LG, Samsung and Whirlpool all recommend monthly, and the panel will often remind you (LG shows tcL after about 30 washes). If a smell has already set in, run it once a week for three weeks.

Is it the detergent making my washer smell?

Usually too much of it. Winnipeg water is moderately hard at about 80 mg/L, not hard enough to need extra soap, and a high-efficiency washer cannot rinse the surplus away. The leftover detergent feeds the mildew. Use the lowest HE dose on the bottle and skip liquid fabric softener.

Why does my washer smell worse in the basement?

Cool, damp basement air keeps a sealed front-load boot wet between loads, and mildew grows fastest in that. Leave the door and the detergent drawer open between washes, and do not let wet laundry sit in the drum.

When is a washer smell a repair and not a cleaning job?

When a musty smell survives three cleaning cycles, there is foul water standing under the pump filter, or the door boot is torn and will not come clean. A burning or electrical smell is always a repair: switch the washer off at the breaker and book service before running it again.

Reviewed November 2026.

(431) 441-3572

Need it today? Call

(431) 441-3572

We book a real arrival window across Winnipeg, diagnose the fault, and quote a firm price before any work.

  • Same-day & next-day service
  • Firm price before any work
  • Service call credited to the repair
  • All major brands, one-visit repairs
Call (431) 441-3572

Winnipeg & surrounding area

Book a repair

Tell us what’s broken and we’ll come back the same business day with a time and a price.

No obligation. The price is quoted before any work. Your details go only to our Winnipeg team.

Broken appliance? Let's get it running.

Same-day service across Winnipeg. Straight pricing, quoted before any work.

Call nowGet a quoteRepair or replace?